X-ray tube is an important component of a medical x-ray machine. If you replace the x-ray tube, you should in the right approach, so as not to damage the medical x-ray machine. I have some suggestions for replacing the x-ray tube, and I hope that they can help you.
1. Preparation:
1) First prepare a x-ray tube with the same model. write down the serial number before installing the x-ray tube.
2) Get ready for 25 # transformer oil .
3) Heat the transformer oil to 100 degrees Celsius.
2. Installation steps:
1) First, open the anode, and you can see a line branching from the set of cable lines. Then remove the line.
2) open the cover of cathode of the x-ray tube.
3) At this step, remove three lines, which is big focus line, small focus line, common lines.
4) Take down the three screws fixed in the x-ray tube, and the take down the three screws fixed to the tube.
5) Now you can put out the circular ring, and the x-ray tube is removed.
6) with the other hand to hold bubtube,a hand hold the x-ray tube to urn under the anti-clockwise directon.By this way you take the x-ray tube down.
7) The installation method is simple. be careful to install the x-ray tube by the opposite order above displaying, and you will make it. Attention: the seat of the x-ray tube must point to the center of the window,
8) after all processes are done, you can pour transformer oil into bulbtube.( transformer oil must be less than 60 degrees Celsius)
9) put the x-ray tube aside for a period of time, or repeatedly drain the air before use.
 

http://www.gzjiayumed.com/en/index.asp